FIRMWARE DOWNLOAD
You can now update (no cost) the latest UltraBeam Antenna Controller firmware.
Now you can download the latest V1.14 firmware.
The update will add new functions to your Antenna Controller without modifying your existing custom modifications.
You only need a Serial Cable with male and female connectors to connect the RS232 port of the Antenna Controller to your Personal Computer.
Once you have your Antenna Controller connected to your Personal Computer follow the download instructions.
---------------------------------------------------------------------------------------------------------------
New firmware v.1.20
Update Protocol CAT.
Some of the latest firmware launched by YAESU
created problems about the connection between radio and controller
The firmware v.1.20 has solved this problem
DOWNLOAD UPDATE : firmware v.1.20
--------------------------------------------------------------------------------------------------------------
New firmware v.1.19
Added the commands for connecting with interfaces miroHAM
DOWNLOAD UPDATE : firmware v.1.19
---------------------------------------------------------------------------------------------------------------
New firmware v.1.18
Adding new "reverse" function (LCD diplay background)
To activate the "reverse" function just reduce the contrast value
MENU - OTHER - DISPLAY - adjust contrast
DOWNLOAD UPDATE : firmware v.1.18
---------------------------------------------------------------------------------------------------------------------
New firmaware v.1.16
CAT protocol for Yaesu Mark-V has now been added.
A three-wires serial cable can now connect your Radio to UltraBeam antenna Controller :
Male connector UB (9 pins) Female connector Mark-V (9 pins)
2----------------------------------------3
3----------------------------------------2
5----------------------------------------5
Once you have selected the protocol Mark-V on the Ultra Beam Antenna Controller the CAT
values of the serial configuration values of your radio will be set automatically
DOWNLOAD UPDATE : firmware v.1.16
------------------------------------------------------------------------------------------------------------
New firmware v.1.15
The CPU will now store the last operating frequency of the band in use.
When changing from an operating band to another the last frequency
which has been used on the selected band will automatically be tuned up.
NOTE: This function is very useful when using the Antenna Control manually.
When the antenna is interfaced to the Radio it will be tracking the frequency of the Radio.
DOWNLOAD UPDATE : firmware v.1.15
--------------------------------------------------------------------------------
The firmware v.1.14 adds
- - Interface : C-IV (Icom); COM (Kenwood); *CAT (Yaesu)
- - Parameters: Baud-rate, Data-bit,Stop-bit, Address etc.
- - Modes displayed: Normal - 180° - Bi-Dir.
- - Direct Retract Element (no need to enter the Menu)
DOWNLOAD UPDATE : firmware v.1.14
* New Yaesu protocol only : FT450-FT950-FT2000-FT9000.
